ABC Design Take Off Instructions For Use Manual page 9

Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product
or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1.Opening the pushchair
a.To open the pushchair, first undo the safety catch on the side of the pushchair.
b.Then pull the handlebar up until it clicks into position. Then push the handlebar and backrest
forwards until the backrest engages on the seat unit.
c.Then pull the handlebar backwards until it clicks into position.
2. Using the brakes
a. Press the lever down to apply the brakes.
b. Press the lever up to release the brakes.
3. Fastening the harness
a. In order to close the harness, first insert the plastic fittings on the lap restraints in the
plastic fittings on the shoulder belts on both sides.
b. Then insert the fittings into the crotch strap fastening.
Adjust the harness to a setting where the baby is held in the correct position.
4. Unfastening the harness
To open the harness, press the catches in on both sides.
CAUTION: Always use the crotch strap and the lap restraint together.
5. Adjusting the backrest
To adjust the position of the backrest, release the clip and use the straps to pull it into the
required position.
6. Befestigen und Abnehmen des Schutzbügels
a.
Um den Schutzbügel zu befestigen, schieben Sie ihn auf beiden Seiten in die Plastikfassung.
b.
Um den Schutzbügel vom Wagen abzunehmen müssen Sie die Knöpfe auf beiden Seiten nach innen
drücken und dann den Schutzbügel nach vorne abziehen.
c. To adjust the height of the guard rail, press and hold down the buttons on each side and
push the rail up or down.
EN - 05