Start Up Your Synology Nas - Synology RackStation RS820RP+ Hardware Installation Manual

To remove the rail kit:
1 To remove the chassis from the rack, hold the rail kit release tabs on the ear holders and pull out the chassis
from the rack.
2 With the help of another person, carefully remove the chassis from the rack. Then, slide forwards to remove
the inner rail from the chassis.

Start up Your Synology NAS

To start up your RS820+ / RS820RP+:
1 Connect one end of each power cord to the power ports located on the back of the RS820+ / RS820RP+ and
the other end to a power outlet.
2 Connect at least one LAN cable to one of the LAN ports and the other end to your switch, router, or hub.
3 Press the power button to turn on the RS820+ / RS820RP+.
Congratulations! Your Synology NAS is now online and detectable from a network computer.
19 Chapter 2: Hardware Setup