Start Up Your Synology Nas - Synology FlashStation FS3600 Hardware Installation Manual

3 Press the power button on the front panel to power on your FS3600. The expansion unit ID of RX1217sas/
RX2417sas connected to FS3600 will be displayed in sequence on the back panel.
Even with the Synology NAS and expansion unit(s) powered on, you can still expand with one or more
Note:
expansion unit if needed. To do so, repeat above steps to connect the expansion cables and power cords of the other
expansion units. Your expansion units will automatically power on if they are correctly connected, and the expansion
unit ID will be displayed accordingly after a few seconds (if DSM is correctly installed in the Synology NAS server).

Start up Your Synology NAS

To start up your FS3600:
1 Connect one end of each power cord to the power ports located on the back of the FS3600 and the other end
to a power outlet.
2 Connect at least one LAN cable to one of the LAN ports and the other end to your switch, router, or hub.
3 Press the power button to turn on the FS3600.
Congratulations! Your Synology NAS is now online and detectable from a network computer.
19 Chapter 2: Hardware Setup