Chapter 2: Hardware Setup; Tools And Parts For Component Installation; Install Drives - Synology RackStation RS820RP+ Hardware Installation Manual

Hardware Setup

Tools and Parts for Component Installation

Please prepare the tools and parts below before setting up your Synology NAS:
• A Screwdriver
• At least one 3.5" or 2.5" SATA drive (please visit
models).
Warning: If you install a drive that contains data, the system will format the drive and erase all existing data. Please
back up any important data before installation.
• Rail mounting kit (please see the Optional Accessories section to find out the suitable rail kit for cabinet
installation)
Warning: We suggest mounting your Synology NAS on a cabinet before installing any drives since the heavy weight
will increase the installation difficulty.

Install Drives

Please follow the steps below for drive installation:
1 Pull the drive tray handle in the direction as indicated below to remove the drive tray.
2 Install drives:
• For 3.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive.
• For 2.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive.
10
www.synology.com/compatibility for compatible drive
2
Chapter