Label Wwpn Address; Install The Cpu Blade; Installing The Driver - NEC N8403-018 User Manual

4-2. Label WWPN address

Label WWPN address and write in "N8403-018" on the Blade management sheet as illustrated
below.
Notice
SLOT #
Model Name :
No. :
FR :
HDD
ID：0
ID：1
Tips

4-3. Install the CPU Blade

Install the CPU Blade in the Blade Enclosure following the instructions in the user's guide of the
CPU Blade.
Avoid installation in extreme temperature conditions.
Immediately after the CPU Blade is powered off, its internal components such as hard
disks are very hot. Leave the computer until its internal components fully cool down
before installing/removing any component.
Connect firmly.
Please connect the product to the CPU Blade firmly. A loose connection can cause a
contact failure and can lead to smoke or fire.

4-4. Installing the Driver

To use this product, the appropriate Fibre Channel driver for your operating system must be installed. For
detailed information, refer to the user's guide of the CPU Blade.
Confirm that the lower 12 figures of Worldwide Name (WWN) match the IEEE
address, before you label.
CPU Blade
MAC Address Label
LAN 1 :
LAN 2 :
N8400-
Option Card Label
WWPN label
The upper line is WWPN for port 0, and the
lower line is for port 1.
WWPN became visible from outside by labeling WWPN address on the Blade
management sheet.
From EM card, WWPN of Port 0/1 are displayed as that of Port 1/2.
Option Card Label
N8403-018
P0 10-00-00-00-C9-5B-00-00
P1 10-00-00-00-C9-5B-00-01
CAUTION
- 37 -