Table of Contents
Advertisement
4> When the menu is displayed, select the number corresponding to the port connected to the Fibre
Channel boot device. Then, you see the information window.
From EM card, Port 0/1 of this product are displayed as Port 1/2.
Tips
Adapter 01:
LPe1105-N:
Port Name: 10000000 C92B6B74
Topology: Auto Topology: Loop First (Default)
The BIOS for this adapter is Disabled
1. Configure Boot Devices
2. Configure This Adapter's Parameters
Enter a Selection: _
Enter <x> to Exit
<d> to Default Values
5> Select 1 to display the Boot device's settings window.
Adapter 01: S_ID:010400
List of Saved Boot Devices:
1. Unused
DID:000000 WWPN:00000000 00000000 LUN:00 Primary Boot
2. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
3. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
4. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
5. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
6. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
7. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
8. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
Select a Boot Entry:_
Enter <x> to Exit
If no Boot device can be detected from this product you selected above, you will
see a message, "This Adapter is not ready, try again!" If you selected a wrong
Notice
number in the above step, press <ESC> key to return to the previous window and
select the correct one.
If you have selected the correct figure, confirm that the Fibre Channel device is
properly connected and its settings are all correct. Then, reboot the CPU Blade
and try these steps from the beginning.
PCI Bus, Device, Function (02,00,00)
I/O Base: 3000
Firmware Version: ZS2.72A2
Node Name: 20000000 C92B6B74
<Esc> to Previous Menu
PCI Bus, Device, Function (02,00,00)
<Esc> to Previous Menu
- 42 -
Advertisement
Table of Contents
