Installing The Rear Hearshield And Blower - HearthStone Castleton 8030 AU Owner's Manual

I R
NSTALLING THE
B
AND LOWER
The blower for the Castleton 8030 must be used in
conjunction with the accessory rear heat shield (90-
68300). Use this blower only with the products
intended and which have markings to indicate such
use. The blower will force air up through the
convection chamber that is formed between the
back of the stove and the heat shield. The lip on the
top of the heat shield will then direct the heated air
out across the top of the stove.
1) Install the heat shield mounting brackets, first
locate the four holes in the back of the stove,
two on the underside of the top and the other
two just under the edge of the bottom about 6"
either side of center (see illustration on page 2).
Place the brackets on the stove so that they line
up with the threaded holes on the back of the
stove and with the larger hooked portion of the
brackets on top, extending upwards. Use the
(4) ¼-20 Phillips screws provided to secure the
brackets.
2) Place the 6 screws (10-24 x 3/8") into the
brackets leaving them loose enough to slide the
heat shield and extension over them. Hold the
heat shield extension up to the brackets (as
shown in illustration) align the two holes on the
shield with the two lowest screws and adjust to
pass screws through the holes. Once both
screws are through the holes slide the heat
shield down to catch the screws in the slots then
tighten to the brackets
Hearthstone Quality Home Heating Products, Inc ®
H S
EAR EAT HIELD
Note: If your stove is installed with the top exit
configuration, proceed to step 3. If your stove is
installed with the rear exit configuration proceed to
step 4.
3) If the rear heat shield filler plate is not attached
to the rear heat shield, do so now. Align the
holes in the filler plate with the holes on the heat
shield and attach using the #8-32 screws
provided. Align the holes in the heat shield with
the (4) screws on the heat shield mounting
bracket (already installed on stove). Pass the
screws through the heat shield holes and slide
the heat shield down to catch the screws into the
slots. Tighten the screws to hold the heat shield
securely in place (see illustrations below).
Top Exit Configuration #1
13
Castleton Model 8030 AU