Table of Contents
Advertisement
D8024/D10024A
Programming
Always verify that the system has found all devices correctly. Use the "Devices" option to obtain
detailed information on the device type and to see the address of each device found on the loop.
5.3.1
Zones
•
The system can be divided into 20, 40 or 80 "zones" for the D10024A panel & 20 "zones" for the D8024
panel. Each zone may contain one or more devices. The zone assignment option allows the commissioning
engineer to quickly assign the sensors to the appropriate zone. It defaults so that all devices are in zone 1.
•
Press 1 from the configure
menu to select the "zones"
option. The display will then
show:
•
This display shows several pieces of information. To avoid ambiguity as to what can be modified, the
display will flash the item that can be changed. If you want to change it, then simply type the new value over
the top. For example:
•
The "from address" number (i.e. 001) will be flashing to show this item can be changed, if required.
To make this address 24,
enter "024". The display will
then show the new zonal
range as :
•
The ">" & "<" keys can be used to move across the display. For example, if the '126' in the "to address"
field is flashing, then the 'zone' field can be modified by pressing the ">" key to make the zone number flash
and then entering the desired value.
•
The backspace "<" key also moves back one digit - useful for correcting errors when entering a numbers.
•
The configuration shown on the display becomes effective immediately after the "Enter" or "Yes" key is
pressed. Pressing the "No" key will abort the operation and return to the commissioning menu.
•
If the "to address" value is less than 126, the "Yes" or "Enter" key automatically advances to the next zone
to be defined.
•
When all of the devices for the loop being configured are assigned to zones, then the program will advance
to the zone description - text entry menu.
•
Each zone can have a description assigned to it to identify the area covered by the zone.
This description will appear
on the liquid crystal display if
a trouble or fire is detected by
any sensor in the zone.
•
The description can be amended by highlighting the location text (using the '>' and '<' keys), pressing
"Change" and entering either, letters, numbers or keywords. This procedure is identical to that used for
editing the sensor location text described in Section 5.5 Location Text on page 23.
5.3.2
Devices
•
The "Devices" option from the display gives information on the various types of device fitted on a loop.
•
Press 2 to select the
"Devices" option. The system
will ask which address you
want to start at:
•
If you would like to start at a different address, then press the "Change" key and enter your required
address, otherwise say "Yes" to continue.
•
The display then gives
detailed information about the
Device at the chosen
address.
50616B
D8024/D10024A Operation and Installation Guide
Page 22
© 2002 Radionics
Advertisement
Table of Contents
