Installation Diagram Notes - Lainox Naboo Compact Series Owner's Manual

Gas-fired or electric combi oven/steamer

Hide thumbs

Table Of Contents

Table of Contents

The Product Identification Plate located on the right side service panel specifies the

electric power requirements.

For each unit, the installer must provide a ground connection and a separate fused

disconnect switch.

Catastrophic damage will result from shifting the more than 3° out of level while power is

turned on at the unit's main power switch.

The unit must have an untreated cold water

122 °F/50 °C) cold softened water

The softened water supply must meet the quality requirements of Table 2-2, and the

pressure requirements on installation diagrams (Fig. 2-2).

A Steamer Gard system is recommended when water quality does not meet the Table 2-2

requirements.

A manual water shut-off valve must be installed between the main softened water supply

and the steamer supply line. Refer to Figures 2-8 and 2-9 for recommended component

arrangements. A manual water shut-off valve must be installed between the main

untreated main water supply and the steam condenser supply line.

The drain line: use a heat-resistant plastic pipe (not flexible), installed without loops

or kinks and no longer than 2 meters with a slope of no less than 4 degrees, or realize

a drain line with a gravity flow away from the Oven. Drain line must not be connected

to the drain lines of any other equipment. In compliance with current standards, the

drainage piping must not be connected in a straight line.

It is advisable to interpose a funnel (see drawing) to facilitate flow. DO NOT REDUCE

THE DRAIN LINE DIAMETER. DO NOT INSTALL A TRAP ON THE DRAIN LINE.

Never block the drain exhaust

NEVER EXCEED 14"/355.6 mm WATER COLUMN (1/2 psi) GAS PRESSURE.

If the gas supply pressure exceeds 14"/355.6 mm water column, a pressure

regulating valve must be installed in the gas supply plumbing to reduce the gas

A main manual gas shut-off valve must be installed between the main gas supply and the

Oven/Steamer gas supply line.

Refer to figures 2-1 for the recommended component arrangements.