Speedtouch™530 Usb Connection Setup - THOMSON 510, 510i, 530 Setup And User Manual

1.2.2. SpeedTouch™530 USB Connection Setup
Supported Operating
Systems
System requirements
Installing the
SpeedTouch™530 USB
connection
3EC 37891 AAAA TCZZA Ed. 01
Installing and using the SpeedTouch™530 USB connection is only supported for
following MS Windows Operating Systems:
•
Microsoft Windows 98/98SE or Microsoft Windows ME
•
Microsoft Windows 2000 or Microsoft Windows XP
You may need the MS Windows installation CD-ROM during installation.
•
For MS Windows 98/98SE/ME:
•
Pentium processor 166 MHz, or higher (or compatible)
•
32 Mega Byte (MB) of memory, or more.
•
For MS Window 2000/XP:
•
Pentium II processor, or higher (or compatible)
•
64 MB of memory, or more.
•
30 MB of free disk space
The installation is Plug-and-Play, meaning that installation will require almost no effort.
Make sure both your PC and SpeedTouch™530 are turned on and operational.
Proceed as follows:
Step
Insert the USB cable provided into the SpeedTouch™530 USB port marked
1
with the USB logo:
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
2
most cases your PC's USB port is marked with the same USB symbol.
Windows will automatically recognize the SpeedTouch™530:
3
The Windows 'Found new Hardware' wizard pops up. This wizard will guide
4
you through the installation procedure of the SpeedTouch™USB drivers. Click
Next to continue.
The following windows of the 'Found new hardware' wizard allow you to
5
select locations where it should search for drivers.
Insert the SpeedTouch™ Setup CD-ROM, make sure that the wizard looks for
the drivers on the CD-ROM drive and click Next to continue.
The wizard will notify that it found drivers for the SpeedTouch™530 on the
6
CD-ROM. Click Next to continue.
1 SpeedTouch™ Installation
Action
.
11