Table of Contents
Advertisement
4.5 General instructions for use
Cutting Operation
- Wait for the drive to reach its maximum speed (about
4 sec)
Do not touch the cutting disc 6 after working before it
has cooled. The cutting disc becomes very hot while
working.
Make sure that the spark guard 20 is properly mounted.
Sparking occurs when cutting metal.
Protect the cutting disc 6 against impact, shock and grease.
Do not subject the cutting disc 6 to lateral pressure.
Do not strain the power tool so heavily that it comes to a
standstill.
Excessive feed considerably reduces the performance
capability of the machine and shortens the service life of the
cutting disc.
Use only cutting discs that are suitable for the material to be
worked.
5. Maintenance and service instructions
5.1 Cleaning
Before any work on the machine itself, pull the mains
plug.
Clean the ventilation slots of your power tool regularly
with a soft brush. The motor fan draws dust into the
housing, and a large accumulation of metal dust can lead to
electrical hazards.
In extreme conditions, always use dust extraction as
far as possible. Blow out ventilation slots frequently
and install a residual current device (RCD). When
working metals, conductive dust can settle in the interior of
the power tool. The total insulation of the power tool can be
impaired.
Have maintenance and repair work performed only by
qualified specialists. In this manner, it can be ensured that
the safety of the power tool is maintained.
The retracting blade guard must always be able to move
freely and retract automatically. Therefore, always keep the
area around the retracting blade guard clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.
5.2 Repair service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as well
as spare parts. Exploded views and information on spare
parts can also be found under:
info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
ENGLISH
11
5.3 Warranty
Warranty card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You should
fill out the card completely and return to vendor with a copy
of purchasing receipt or invoice and you should receive a
receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
5.4 Disposal and recycling
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be
collected separately and disposed of in an
environmentally correct manner.
Subject to change without notice.
6. Regulations
6.1 Technical Data
= Power input
= No load speed
rpm
Ø
= Disc dimension
Ins
= Protection class
= Weigth
L
= Sound power level
WA
L
= Sound pressure level
A
P
= Vibration
The values given are valid for nominal voltages [U] 230/240 V ~
50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and models for
specific countries, these values can vary. Please observe the
article number on the type plate of your machine. The trade
names of the individual machines may vary.
Noise/Vibration Information
Measured sound values determined according to EN 61029.
Typically the A-weighted noise levels of the product are:
Sound pressure level 97 dB(A); Sound power level 108 dB(A).
Uncertainty K=3 dB.
Wear hearing protection!
11
Advertisement
Table of Contents
