Solid-State Drive; Removing The Solid-State Drive - Dell Inspiron 24-5491 Service Manual

Steps
1. Connect the antenna cables to the wireless card.
The following table provides the antenna-cable color scheme for the wireless card supported by your computer.
Table 2. Antenna-cable color scheme
Connectors on the wireless card
Main (white triangle)
Auxiliary (black triangle)
2. Place the wireless-card bracket on the wireless card.
3. Align the notch on the wireless card with the tab on the wireless-card slot.
4. Slide the wireless card at an angle into the wireless-card slot.
5. Replace the screw (M2x4) that secures the wireless-card bracket to the wireless card.
6. Align and place the wireless-card shield on the system board and wireless card.
7. Replace the two screws (M2x4) that secures the wireless-card shield to the system board.
Next steps
1. Install the system-board
2. Install the stand.
3. Install the bottom cover.
4. Install the back cover.
5. Follow the procedure in

Solid-state drive

Removing the solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the back cover.
3. Remove the bottom cover.
4. Remove the stand.
5. Remove the system-board
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
shield.
After working inside your computer.
Before working inside your
shield.
Antenna-cable color
White
Black
computer.
Removing and installing components 29