Closing The Device; Switching On The Device; Operation; Charging The Vehicle - Mennekes Compact Series Operating And Installation Manual

5.12 Closing the device

Fig.: 12. Closing the device
f Fold the enclosure cover upwards.
f Press the enclosure cover until it clicks audibly into
place.

5.13 Switching on the device

T
T
DANGER
Electric shock hazard in case of damaged devices
Using a damaged device may result in electric shock.
f Do not use the device if it is damaged.
f Mark the damaged device to ensure that it is not used
by others.
f Eliminate damage immediately.
f If necessary take the device out of service.
Precondition:
„ Residual current and miniature circuit breakers are
installed on site and suitably dimensioned.
„ Device is correctly installed and connected.
„ The device is in a proper condition.
f Switching on the power supply

6. Operation

6.1

Charging the vehicle

T
T
WARNING
Risk of injury from using unsuitable aids
Use of adaptor plugs, extensions, or additional charging
cables in connection with the device can result in electric
shock or cable fire.
f Use only the charging cable intended for the vehicle
and the device.
f Do not use adaptor plugs, extensions, or additional
charging cables to charge the vehicle.
Prior authorisation is not necessary.
f Fully unroll the charging cable from the cable holder.
f Connect the charging cable to the vehicle.
9 All requirements for proper charging are verified.
The charging process starts automatically.
9
Terminating the charging process
T
T
ATTENTION
Damage to the charging cable
Tensile stress on the charging cable may cause cable
breaks and other damage.
f Only pull the charging cable directly from the socket
outlet.
f End the charging process on the vehicle.
f Pull the charging cable out of the charging socket on
the plug.
f Fit on the protective cap.
f Hang or store the charging cable kink-free.
For a type 1 charging connector, press the release
button to unplug.
EN
13