Installation Of The Gsm Control Unit And Its Antenna; Tamper Detector - jablotron Azor User Manual

Installation of the GSM control unit and its antenna

• The GSM control unit should be installed in a concealed place. There must be a
power socket for the connection of the supplied power adaptor within reach.
• If the LED indication on the front panel of the control unit is unwanted (may
show the place of unit installation) it is possible to switch it off using A-Link. The
LED indication is switched off within 15 minutes. If you need to check the
indication briefly press the button on the unit and the indication will appear for
15 minutes. In the case of power trouble the LED indication is always on.
• Neither other electronic appliances nor low current cabling should be near the
GSM control unit (e.g. audio systems, antenna cables) which may be affected
by the GSM transmitter in the control unit.
• You can use the template on the back of the manual to mark the spots where
you want to fix Azor to the wall. The screws should protrude a bit so that the box
with electronics can be mounted on the screw heads and secured by moving it
sideways.

Tamper detector

The GSM control unit has a sensitive tamper-switch at the bottom (a plastic
lever). The switch reacts to the GSM control unit being picked up from a surface. In
such a case the system will send a tamper activation report.
- 11 - MLO51206