Installation; Electrical Connection - Baumatic P640SS Instruction Manual

I NST ALLATION
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European Norm
Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Stand
Department).
o IEE Wiring Regulations.
o Elec tricity At Work Regulations.
Before connecting the appliance, make sure that the supply voltage
ma e rk d on the Rating Plate corresponds with your mains supply
voltag e.
WARNING: THIS APPLIANCE MUST BE EARTHED.
This appliance
o
fused spur outlet, having 3
an easily accessible position adjacen
outlet must still be accessible even when your oven is located in
its housing.
To connect the oven power cord, loosen and remove the cover
o
on the terminal block, in order to gain access to the contacts
inside. Make the connection, securing the cord in place with the
cable clamp
block cover again.
o If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
o Care must be taken to ensure that the temperature of the main
supply cable does not exceed 50°C.
If the mains supply cable is damaged, then it must be replaced
o
by an appropriate r
Baumatic Spares Department.
ards (issued by the Scottish Development
should be wired into a 16 A double pole switched
mm contact separation and placed in
provided and then immediately close the terminal
eplacement which can be obtained from the
t to the appliance. The spur
s
23