Table of Contents
Advertisement
N o t e
Overview
Before you install the HP AdvanceStack Switch 100VG Module into the
Switch 2000, you should install an optional HP 100VG Transceiver
module in one or both of the 100VG transceiver slots in the module.
(Refer to the instructions you received with the transceiver.)
You can install a 100VG Module into the Switch 2000 in any one of the six
module slots, as follows:
1. Install the 100VG Module in a Switch 2000 slot (page 2).
2. Customize the configuration for the module ports (unless the default
port configuration is satisfactory for your network application - see
page 7).
3. Reboot the switch (page 8).
Other, optional procedures include:
Hot-Swapping one module for another; that is, replacing one module
with another without turning off power to the switch (page 9)
Using the hot-swap process to install a transceiver into a module
that has already been installed in the switch (page 11)
1
Advertisement
Table of Contents
