Connection Of The External Sensor Probe; Remote Control Wall Mounting - Baxi Luna 3 Comfort Series Installation And Servicing Instructions

To wall-mount the remote control, proceed as follows:
1. Undo the two screws (a-b figure 26) fixing the casing to the boiler;
. access the terminal block M as shown in the figure 27;
3. remove the two blue wires from the terminals 1- and connect the two wires coming from the remote control.
TERMINAL BLOCK M
TO THE REMOTE CONTROL
Figure 7
IMportant: After installing the remote control, switch the power on to the appliance, making sure that the remote
control works properly.

8. connection of the external sensor probe

The boiler is prearranged for connection of an external probe (supplied as accessory).
For the connection, refer to the figure below (terminals 3-4) and the instructions supplied with the probe.
TERMINAL BLOCK M
Figure 8
Figure 8.1
InstructIons pertaInInG to tHe Installer

7.2 remote control wall mounting

CN5
cn5
Connect the cable, supplied as an accessory together
with the external probe, to the cn5 connector of the boiler
electronic board, as illustrated in figure 28.1.
Remove the two-pin terminal block connected to the
cable and connect the terminals to terminals 3-4 on the
M terminal block, as illustrated in figure 28.
7
95.188.3 - GB