Coin Box Instructions; Install Coin Slide Mechanism; Starting Dryer Without Using Coin Slide Mechanism; Changing Nylon Timing Cams - Kenmore 110.70012 Series Use & Care Manual

Install Coin Slide Mechanism

1.
Coin slide mechanism installation
B
A
Unplug dryer or disconnect power. Remove service door from
meter case by unlocking service lock with key shipped with
dryer. Carefully insert coin slide mechanism (B) into opening
and guide into holes. Secure coin slide with bolt (A) from inside
meter case (C).
NOTE: Removing timer from mounting screws may facilitate
inserting bolt.
Replace service door. Be sure lock is located toward rear
of case.
2.
Coin box adjustment
A
The tight fit of the money box is set at the factory. Customer
may loosen fit as desired by loosening the slotted nuts (A).
Keep a record of all coin-box key numbers. A lost key can
only be replaced if ordered by key number from Sears Parts.
The key number is located both on the key and behind the end
panel of coin box. If the key number is not available, the lock
must be drilled out to remove the coin box.
18

COIN BOX INSTRUCTIONS

C
Unplug dryer or disconnect power. Open meter case service
door (A) with top-lock key and remove meter case service door
(A). Push the ratchet arm (B) towards the rear of the dryer until
it stops, then release. Replace the meter case service door (A).
Be sure the lock is located toward the rear of the case. Plug in
dryer or reconnect power.
The timer is set to provide 60 minutes (3 pins - green cam) of
drying time when activated by the coin slide. Each time coin slide
deposits coins (push in and pull back) and the coin slide will hold
a maximum of 10 coins.
Timer cams for 30-minute (6 pins - red cam) and 45-minute
(4 pins - yellow cam) drying times are included in the parts bag.
Starting Dryer Without
Using Coin Slide Mechanism
1.
Remove meter case service door
A
B

Changing Nylon Timing Cams