Kenmore 110.70012 Series Use & Care Manual page 17

9.
Remove door strike
Remove door strike from dryer cabinet and set aside.
10.
Remove and transfer
hinge hole plugs
Use a small, flat-blade screwdriver to gently remove 4 hinge
hole plugs on left side of dryer cabinet. Transfer plugs into
hinge holes on opposite side of dryer cabinet.
11.
Insert screws in hinge holes on
dryer cabinet
NOTE: Two people maybe needed to reinstall door.
Insert screws into the bottom holes on left side of dryer
cabinet. Tighten screws halfway. Position door so large
end of door hinge slot is over screws. Slide door up so
screws are in bottom of slots. Tighten screws. Insert and
tighten top screws in hinges.
12.
Remove door strike plug
Remove door strike plug. Insert the door strike removed in Step
9 into hole and secure with screw. Insert door strike plug into
original door strike hole and secure with screw.
13.
Check door strike alignment
Close door and check that door strike aligns with door
catch. If it is needed, slide door catch left or right within slot
to adjust alignment.
17