Stryker Power-PRO TL Cot Operation Manual page 10

• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). If it is used in a residential environment, for which CISPR 11 class B is normally required, this equipment might
not offer adequate protection to radio frequency communication services. The user might need to take mitigation
measures, such as relocating or reorienting the equipment.
• Portable RF communications equipment, including peripherals such as antenna cables and external antennas, should
be used no closer than 12 inches (30 cm) to any part of P P o o w w e e r r - - P P R R O O and S S M M R R T T charger, including cables specified by
the manufacturer.
• Avoid stacking or placing other equipment adjacent to P P o o w w e e r r - - P P R R O O and S S M M R R T T charger to prevent improper operation of
the products. If such use is necessary, carefully observe P P o o w w e e r r - - P P R R O O and S S M M R R T T charger and the other equipment to
make sure that they are operating properly.
P P i i n n c c h h p p o o i i n n t t s s
W W A A R R N N I I N N G G - - Always keep your hands clear of the red safety bar pivots when you load, unload, or change the height
position of the cot.
M M e e c c h h a a n n i i c c a a l l s s t t a a b b i i l l i i t t y y
W W A A R R N N I I N N G G - - Always use both hands when transporting the cot.
EN 6
F F i i g g u u r r e e 1 1 – – P P i i n n c c h h p p o o i i n n t t s s
6550-309-005 Rev H.0