Printer Initialization By The Indicator Operation; Input Commands; Serial Interface - Jadever JWL Series Manual

/MR TARE/
or
The number of weighments is indicated by Auxiliary display at the left bottom.
XX=Total accumulation； XX=certain accumulation
Accumulation Clear
To clear accumulation data (total accumulation data or one of the accumulation events), press key
M-/SET
while the data is displayed. To exit and return to normal weighing mode press key
ZERO/ESC.

7-6 Printer initialization by the indicator operation

M-/SET
1. Press while powering on to enter parameter setting. Use key
shift to P09
M-/SET
2. Press
printer model
3. Shift to certain printer model. Press
"UNSUP" means the printer is no need for initialization. Press
"init?" means the printer is should be initialized. Press
the initialization is finished, the window will show "ok". And then displays the printer model. Press
ZERO/ESC
to return.

7-7 Input commands

Connect the indicator and computer. Run serial port debugging program on the computer. Input the
capital number "Z", "T", "R" ,"C","P"in the sending area, and the indicator can conduct the
corresponding actions.
Z=zero
T=tare
C=cancel tare
R/P=reading / print

8. Serial Interface

to check the total accumulation and each accumulation event in detail.
to enter the external device setting. Press
(II)
M-/SET
and the window will show "UNSUP" or "INIT?"
MR/SAVE
JWL
/MR
/MR TARE/
or
ZERO/ESC
to return.
to initialize the printer. When
TARE/
to
or
to choose the
13