Check Weighing - Jadever JWL Series Manual

HOLD/LO/-
to change the value. Press
3) Put the load on the container, the scale will automatically deduct the value of the container
from the total value.
NOTE: Press Key
4) Clear the load on the container, and press

7-3 Check Weighing

Lower limit setting
1. Begin by pressing down key
right-most digit blinking.
2. To set the value of lower limit, press key
rightwards, key
setting value. Key
3. To save the Lower limit and return to weighing mode, Press key
Upper limit setting
1. Begin by pressing down key
right-most digit blinking.
2. To set the value of upper limit, press key
rightwards, key
setting value.
3. To save the upper limit and return to weighing mode, press key
Place the sample on the weighing pan, if the sample weight is under the lower weight range while
over or equal 20d, the LOW lamp will light up. If the sample is within the lower and upper weight range
while over or equal 20d, the OK lamp will light up. If the sample is over the upper weight range while
G/N
to display gross and net weight by turns.
HOLD/LO/-
+/PRINT/HI
to increase setting values and key
M-/SET
to enable or disable the weighing checking function.
+/PRINT/HI.
+/PRINT/HI
to increase setting values and key
(II)
M+/SAVE
to save and return to weighing mode.
TARE/ ZERO/ESC
or
The scale is now in digital inputting mode with the
.
/MR
to shift leftwards, key
The scale is now in digital inputting mode with the
/MR
to shift leftwards, key
JWL
to cancel the pre-tare.
TARE/
HOLD/LO/-
M+/SAVE
TARE/
HOLD/LO/-
M+/SAVE
to shift
to decrease
to shift
to decrease
11