Information On Sharpening; Maintenance And Cleaning - Grizzly KSG 220 Translation Of The Original Instructions For Use

the grinding disc.
2. Fix the chain link to be sharpened
with the help of the stop (10) and the
fixing bolt (9).
Adjusting the sharpening angle:
3. Undo the locking bolt (16) on the un-
derside of the device.
4. Set the correct sharpening angle (17)
with the aid of the rotary table (14).
5. Retighten the locking bolt.
Adjusting depth stop and stop:
6. Adjust the depth stop with the aid of
the adjusting bolt (20).
7. Move the cutting edge of the chain
link towards the grinding disc using
the adjusting bolt (11).
Sharpening:
8. Tilt the grinding disc housing to the
rear and switch the device on (see
„Switching on and off").
9. Sharpen the cutting tooth by pushing
gently on the grip.
10. Switch the device off before moving
the chain further.
Unloose the fixing bolt (9) and fix the next
chain link to be sharpened with the help of
the stop (10) and the fixing bolt (9).
Information on
sharpening
• The cutting parts of the chain are the
cutting links which consist of a cutting
tooth and a depth limiting nib. The
height difference between these two
determines the sharpening depth.
• First sharpen the teeth on one side.
Then adjust the sharpening angle and
sharpen the teeth on the other side.
• After sharpening, all the cutting links
must have the same length and
breadth.
• After every third sharpening, the
sharpening depth (depth limitation)
must be checked, and the height must
be filed down using a flat file. The
depth limitation should be set back
approximately 0.65 mm
compared to the cutting
tooth. After filing the
depth limitation down,
round it off by slightly slid-
ing forward.
• The chain has become worn down
and must be replaced by a new saw
chain when only around 4 mm of the
cutting tooth remains.
• Adjust the transparent cover regularly
in order to compensate for wear on
the grinding disc (see chapter „Initial
start-up").
Maintenance and
cleaning
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described in
these instructions carried out by
a specialist workshop. Use only
original components. Allow the
equipment to cool before car-
rying out any maintenance and
cleaning work. There is a risk of
burns.
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disk (
18). Replace damaged parts.
GB
127