PB TEEN Egg Desk Chair Assembly Instructions

Advertisement

Egg Desk Chair

PRE-ASSEMBLY:

Please read all instruction before beginning assembly. The illustrations provided allow for
easier assembly when used in conjunction with the assembly instructions.
Remove all parts and hardware from box and lay out on a carpeted or scratch-free work
surface, as this will avoid damaging any parts during assembly. The shipping box
provides and ideal work surface. Do not dispose of any contents until assembly is
completed to avoid accidentally discarding small parts or hardware.
For your safety and ease, adult assembly by two people is recommended.
Save all packing materials until assembly is complete to avoid accidentally discarding
smaller parts or hardware.
Use the parts and hardware lists to identify and separate each of the pieces included
prior to starting assembly.
Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these
instructions may cause the bolts to misalign during assembly.
If using power tools to aid in assembly please use it carefully, not over tighten. Power
tools can damage hardware or split wood.
1/3
2012-09-03

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Egg Desk Chair and is the answer not in the manual?

Questions and answers

Summary of Contents for PB TEEN Egg Desk Chair

  • Page 1 Egg Desk Chair PRE-ASSEMBLY:  Please read all instruction before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.  Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface, as this will avoid damaging any parts during assembly.
  • Page 2 PARTS ENCLOSED: (A) Seat – 1pc (B) Chair Base – 1pc (C) Seat Plate – 1pc (D) Gas Lift Post – 1pc (E) Casters – 5pcs (F) Bolt M8X1”L – 4pcs – 1pc Allen key ASSEMBLY INSTRUCTIONS: Step1. Insert Casters (E) to Chair Base (B) by pressing firmly until casters locked. Step2.
  • Page 3 Step3. Attached seat plate (C) to Seat (A) using Bolts (F) with Allen Key (G). Step4. Put Seat (A) to Gas Lift Post (D) by pressing firmly with Seat plate (C). Assembly completed. Step5. Care Instructions:  Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if necessary.

Table of Contents