Environmental Information - Bowers & Wilkins PX Manual

1. PX Carton Contents

Environmental Information

2. Getting To Know PX headphones
i. PX Wireless Headphones
Note: Indicator illumination is listed in Diagram 7.
Note: Audio cues can be toggled on and off by
pressing the Play/Pause and Volume + buttons
simultaneously.
Note: Connecting audio jack and USB cables is
described in Section 10.
Note: Button functions are listed in Diagram 8.
ii. USB charging cable
iii. Audio jack cable
iv. Storage pouch
v. Literature pack
This product complies with international directives,
including but not limited to the Restriction of
Hazardous Substances (RoHS) in electrical and
electronic equipment, the Registration, Evaluation,
Authorisation and restriction of Chemicals (REACH)
and the disposal of Waste Electrical and Electronic
Equipment (WEEE). Consult your local waste
disposal authority for guidance on how properly to
recycle or dispose of this product.
Once switched on via the power slide-switch on the
right hand ear-piece, your PX headphones can be
controlled via Play/Pause and Volume buttons also
located on the right hand ear piece. A connected
Bluetooth or USB device will also be able to control
headphone volume and audio playback.
An indicator alongside the Bluetooth button displays
connection status and battery charge level. The
headphones also play audio cues for some control
commands and events.
A USB socket and an audio jack socket are located
on the underside of the right hand ear-piece. The
right hand ear piece also incorporates a pin-hole
restart button beneath the ear pad.
PX headphones incorporate proximity sensors in
their ear-pieces that mean they will enter standby
mode and disconnect from any connected Bluetooth
devices two minutes after removal from the head.
They will automatically wake from standby and
connect to the last connected Bluetooth device
when worn on the head.
A press button alongside the power button enables
and disables Environment Filter noise-management.
When enabled, Environment Filter operates on
all three headphone inputs: Bluetooth, USB and
audio jack.
The Bowers & Wilkins Headphone app provides
extended set up and control functions, including
Environment Filter and Voice Pass-through,
adjustment and mode selection. Ear-piece proximity
sensor sensitivity can also be adjusted within the
app. The app is available as a free download for iOS
and Android devices.
Left
Right
Diagram 1
Pin-hole restart button
Main features
Diagram 2
Underside view
Right
Volume +
Play/Pause
Volume -
Environment Filter
Power/Bluetooth
Left
Indicator
USB charging socket
Audio cable socket
3