Stiga MP2 504 Series Operator's Manual page 123

To change the handle height, pull both levers on the handle
sides (Fig.15.B) (Type "I"- "II"), and hold them in position.
Move the handle carefully to the desired
height and release the two levers.
It is also possible to fold the handle to the
closed position from the working position.
6.2 SAFETY CHECKS
Run the following safety checks and check that the
results correspond to those outlined on the tables.
Always carry out the safety checks before use.
6.2.1 General safety check
Object
Grips
Handle
Cutting means
Rear discharge guard;
grass catcher
Side discharge guard,
side discharge chute
Engine brake lever
/ cutting means
Starter cable
Screws/nuts on the
machine and on the
cutting means
Electric cables and
spark plug cable
Spark plug cap
Machine
6.2.2 Machine operating test
Action
Result
Clean, dry.
Fixed firmly to the machine.
Clean, not damaged
or worn.
Good condition. No
damage. Properly installed.
Good condition. No
damage. Properly installed.
The lever must move
freely, it must not need
forcing and should
return automatically
and rapidly back to
the neutral position.
The cable must be intact.
Correctly tightened
(not loose).
Intact to prevent sparks
from occurring
Intact and correctly fitted
on the spark plug.
No signs of damage
or wear.
Result
1. Start the machine
(par. 6.3).
2. Release the engine
/ cutting means
brake lever.
1. Start the machine
(par. 6.3).
2. Engage the
drive lever.
Disengage the
3.
drive lever.
Test driving
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
a service centre to have it checked and repaired if ne-
cessary.
6.3 START-UP
NOTE Start up the machine on a flat
surface without obstacles or high grass.
6.3.1 Manual starter handgrip models
1. For cold starts: move the throttle to the "Choke"
engaged position (Fig.6.A) (if present).
2. Pull the engine cutting means brake
lever towards the handle (Fig.16.A).
NOTE Keep pulling the engine / cutting
means brake or the engine will stop.
3. Grab hold of the starter handgrip and tug the
starter cable firmly to start the engine (Fig.16.B).
4. When the engine has started, shift the
throttle to the full speed position (if fitted).
NOTE Using the choke when the engine
is already warm can foul the spark plugs and
cause the engine to run erratically.
6.3.2 Electric push-button starter
switch models
EN - 7
1. The cutting means
should move.
2. The levers should
return automatically
and rapidly to the
neutral position, the
engine must switch
off and the cutting
means must stop
within a few seconds.
2. The wheels
should move the
machine forward.
3. The wheels should
stop and the machine
stops moving forward.
No abnormal vibrations.
No abnormal sound.