Tascam CD-VT1MKII Owner's Manual page 8

About the power supply (Continued)
 Being in Stop mode
 CD drive cover is open
 No CD is loaded
To turn the CD player on, press the
PLAY key.
CAUTION
Because the CD-VT1MKII is equipped with
special functions such as key change and
effects, the battery life is shorter compared
with standard portable CD players.
The length of battery life in CD-VT1MKII is
affected by both the environment and the
number of functions in use. Factors that af-
fect battery life include temperature, humid-
ity, the number of special functions used, and
so on.
Under some circumstances, there may not be
enough power in the batteries to power the
CD-VT1MKII, despite the battery power indi-
cation on the display. If this happens, change
the batteries, or use an AC adapter.
Always dispose of used batteries as recom-
mended by your local authorities.
8
— TASCAM CD-VT1MKII
Operation using an AC
adapter
Connect a TASCAM PS-PS5 AC
adapter (sold separately) to the
jack at the back of the CD-VT1MKII.
Insert the plug of the AC adapter into
a domestic AC power outlet. Make
sure that the voltage of the outlet corre-
sponds to that marked on the adapter.
PS-PS5
DC plug
WARNING
Use only a PS-PS5 AC adapter with your CD-
VT1MKII. Using another type of AC adapter
may damage your CD-VT1MKII.
Remove the batteries before operating the
CD-VT1MKII with an AC adapter. There is a
possibility of slight noise if you use the unit
with an AC adapter while the batteries are
inside. If you plug in an AC adapter but have
forgotten to take out the batteries, turn the
power off using the
take out the batteries. Likewise, turn the
DC IN
power off before you change between using
the batteries and using the AC adapter.
Unplug the AC adapter from the domestic
AC power outlet when you are not using the
CD-VT1MKII.
Settings may not be properly saved if you
turn the power off immediately after insert-
Wall outlet
ing a CD or changing settings. If settings are
not saved properly, the system may not start
with the last settings and instead will start
using the default values.
Switching the unit on and off
Use the POWER
power to the whole unit on and off.
N
POWER
switch, and
switch to turn the