Using Built-In Effects - Tascam CD-VT1MKII Owner's Manual

(continued from the previous page)
Tap the CD EFF/SETUP
the CD Effect menu, and select
pressing either the PREV or
Press the UP or DOWN
from the following:
 : outputs the sound of the CD
C-M
from the left, and the sound of the
microphone(s) from the right.
 : outputs the sound of the
M-C
microphone(s) from the left, and
the CD sound from the right.
 : outputs stereo mixed sound of
OFF
CD and microphone(s) from left
and right.

Using built-in effects

The effector of the CD-VT1MKII
consists of an effect library and a voice
change function.
Effect Library
There are 18 built-in preset effects.
You can adjust the parameters for each
of them.
Voice Change function
The Voice Change function allows
key to enter
you to raise or lower the pitch of the
by
SPLT
sound input from the microphone(s)
NEXT key.
by 1 octave.
key to select
Using the effector
1. Switch the
switch to ON.
2. Press the
Effect menu.
3. Select
NEXT
4. Use either the
select the preset effect (01-18).
5. Select
PREV
ther the
the effect parameters (effect val-
ues).
EFFECT ON/OFF
EFFECT key to open the
using either the PREV
EFF
key.
UP or DOWN key to
by pressing either the
PAR
or NEXT key, then press ei-
UP or DOWN key to set
Using built-in effects
6. Press the TIME/ESC
the Effect menu. The parameters
you have selected are automati-
cally stored.
Using the voice change
1. Switch the EFFECT ON/OFF
switch to ON.
2. Press the
V.CHANGE
the voice change menu.
3. Press either the
to select from the following:
 : raises the pitch of the sound
UP
from the microphone by 1 octave
 : the sound from the micro-
OFF
or
phone is not affected
 : lowers the pitch of the sound
DN
from the microphone by 1 octave
4. Press the TIME/ESC
the voice change menu.
TASCAM CD-VT1MKII —
key to exit
key to open
UP or DOWN key
key to exit
19