Voice First/Tone First - NEC Univerge SV9300 Series User Manual

VOICE FIRST/TONE FIRST

This feature allows incoming calls to your terminal
to either ring or go to voice announcement.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator.
TO SET VOICE FIRST/TONE
FIRST MODE
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial Voice First/Tone First access
code or press Voice First/Tone First
feature key.
LCD shows current mode.
You will receive a feature dial tone.
VOICE
4:26 PM MON 11 MAY 2015
Recall PICK
3. Dial any single digit (
Voice First mode is switched to Tone First
mode (or vice versa).
You will receive a feature set tone.
TONE
4:26 PM MON 11 MAY 2015
Recall PICK
4. Press Speaker key.
Speaker key lamp goes off. →
5. The called party can reply.
WHEN A CALLED TERMINAL
HAS BEEN SET TO VOICE
FIRST
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
>>>>
- ).
>>>>
80
2. Dial extension number.
Wait for voice page alert tone.
VOICE CALL
4:26 PM MON 11 MAY 2015
R-TONE MIC
3. Speak to the called party.
4. Dial .
The called party's extension will ring.
4:26 PM MON 11 MAY 2015
R-TONE MIC
WHEN A CALLED TERMINAL
HAS BEEN SET TO TONE
FIRST
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
2. Dial extension number.
The called party's extension will ring.
4:26 PM MON 11 MAY 2015
R-TONE MIC
3. Dial .
Wait for voice page alert tone.
VOICE CALL
4:26 PM MON 11 MAY 2015
R-TONE MIC
4. Start conversation with called party.
5. The called party can reply.
FEATURE OPERATION
200
200
200
200