Table of Contents
Advertisement
6. Instructions for use
6-1 How to use //
Parameter setting
1. In the normal state, press the "Preset channel
button ▲/▼" to fast select the preset channels *
01 ~ * 96. (* are for bands 1 to 3, or groups A to E).
Quick setting icon: Preset channels are 01 to 90 and
group channels are 91 to 96.
Example 1:Preset channels for Band 1 and
Group 2 are shown as 102.
Example 2: Group B Channel 93 is shown
as b93.
Note: It is not recommended to mix the default
channel with the group channel.
2. Press "SET" for two seconds to enter
the setting mode, then press ▲/▼ key
to select the relevant parameter to set
RX (receiver) or TX (transmitter).
Select RX Receiver
◎ FREQ Frequency setting
Take 1MHz as the unit
Take0.025MHz as the unit
◎ ATT. Audio output attenuation(XLR)
At OFF
Audio output without attenuation
At On
Audio output attenuation 20dB
Preset channel▲/▼Key
Press▲/▼ key to set
frequency
Press▲/▼ key to set
frequency
R -988 KB
UHF PLL DUAL CHANNEL DIVERSI TY RECEIVER
Set the frequency number that takes 1MHz
as the unit first, and then set the frequency
number that takes 0.025MHz as the unit.
Indicates that the function is turned on, and
the output attenuation is 20dB
16
Advertisement
Table of Contents
