Canon EOS M200 Advanced User's Manual page 408

Responding to Error Messages
11: Connection target not found
In the case of [q], is Camera Connect running?
z
Establish a connection using Camera Connect ( = 335).
B
In the case of [ D ], is the EOS software running?
z
Start the EOS software and reestablish the connection ( = 353).
B
In the case of [ l ], is the power of the printer on?
z
Turn on the printer.
B
Are the camera and the access point set to use the same password for
z
authentication?
This error occurs if the passwords do not match when the
B
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct password for authentication is
set on the camera ( = 406).
12: Connection target not found
Is the power of the target device and access point on?
z
Turn on the target device and access point, then wait a while. If a
B
connection still cannot be established, perform the procedures to
establish the connection again.
408