Assembly Instructions - Tanita WB-300 Operating Instructions Manual

5. Assembly Instructions

List of Components
Base (fully assembled and
1
pre-wired to display assembly)
Lower Pillar Assembly
2
Tightening Knob
3
Lower Height Rod Assembly
4
Top Height Rod Assembly
5
(fully assembled with pivoting
height measuring lever)
Top Head Display Assembly
6
(fully assembled and
pre-wired to base)
7 Height Rod Arm
8 Wire Harness
If the scale is to be disassembled,
please use this plastic tool to
separate the two pillars.
1. Carefully remove all components from the box.
2. Place all items on the floor side by side. Make sure not to excessively pull the wire harness that
connects the base (1) to the top assembly (6).
3. Carefully pull wire harness on topside of lower pillar (2) as pillar is inserted into the base (1). This will
minimize the length of straight wire and ease assembly.
4. Once the lower pillar (2) is placed firmly in the base (1), tighten the knob (3) to the threaded stud located
underneath the base.
5. Snap the top assembly (6) into the lower pillar assembly (2). Make sure to push in the excess length of
coiled wire harness (8) into the open ends of the two pillars as you bring them together. Be careful not
to pinch the coiled wire harness (8) between the two pillars.
6. Assemble the height rod arm (7) to upper height rod (5) from the bottom of upper height rod.
7. Assemble the top height rod assembly (5) to the lower height rod (4). Slide the assembled height rod
into the height rod opening on the pillar assembly. Push all the way down.
Note: For scales without height rod skip steps 6 & 7.
7
5
5
4
7
1
5
6
8
2
3