Replacing Batteries; Resetting The Scale; Calibration - Tanita WB-300 Operating Instructions Manual

Replacing Batteries

The scale is operated by three (3) replaceable AA alkaline batteries for weighing and (one) 3-volt CR123
Lithium battery for clock operation. The battery box is located on the back of the LCD display.
1. Lift and remove the battery compartment cover located on the back of the LCD display.
2. Insert batteries with the correct polarity.
3. Replace the battery compartment cover and push it until you hear the click sound.
If the lithium battery was replaced, the clock needs to be reprogrammed.

Resetting the Scale

After battery replacement, the scale may need to be reset in the following situation:
1. If the batteries were installed in the incorrect polarity — after being replaced in the correct polarity.
2. When the low battery sign(s) is still displayed even after the new batteries are installed.
In order to reset the scale, take a ball point pen to push a button hidden behind the lithium battery.
Please reprogram the clock.

9. Calibration

This product has been properly calibrated at the factory. You must have certified weights in order to
properly calibrate this product. The calibration procedure is available upon request. Please call our
customer service to request the calibration manual.
Lithium
A A alkaline
A A alkaline
A A alkaline
13