Table of Contents
Advertisement
ELECTRONIC PHYSICIAN SCALE
MODEL WB-300, WB-300MH, WB-300DH
Operating Instruction Manual
Table of Contents
1. Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Important Notes for Users . . . . . . . . . . . . . . . . . . . . . . 2
3. Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
4. Key Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
5. Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 5
6. Before Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
7. Instructions for Use . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
8. General Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . 12
9. Calibration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Please keep this manual in a safe place, and make sure it is readily
available whenever necessary. Please use this product only after
carefully reading this manual and fully understanding its contents.
'AdEr,' 'LoL'
Advertisement
Table of Contents
Related Manuals for Tanita WB-300
Summary of Contents for Tanita WB-300
-
Page 1: Table Of Contents
ELECTRONIC PHYSICIAN SCALE MODEL WB-300, WB-300MH, WB-300DH Operating Instruction Manual Table of Contents 1. Product Specifications ......2 2. -
Page 2: Product Specifications
Product Model ........ -
Page 3: Components
3. Components Description Standard Features: WB-300, WB-300MH, WB-300DH Measuring Platform Weight LCD Clock LCD Battery Compartment Height Rod Arm (For WB-300MH and WB-300DH) Height Rod Sliding Block Upper Pillar Column Four feet on the bottom of platform WB-300MH/WB-300DH WB-300... -
Page 4: Key Operation
4. Key Operation Weight LCD Right Side Clock LCD WB-300DH version only Right Side Clock LCD WB-300 and WB-300MH versions only... -
Page 5: Assembly Instructions
5. Assembly Instructions List of Components Base (fully assembled and pre-wired to display assembly) Lower Pillar Assembly Tightening Knob Lower Height Rod Assembly Top Height Rod Assembly (fully assembled with pivoting height measuring lever) Top Head Display Assembly (fully assembled and pre-wired to base) Height Rod Arm Wire Harness... -
Page 6: Before Use
6. Before Use Level the Scale For best results, place the scale on a hard, even surface or carpet without padding. If the four feet located on the bottom of the platform do not make full contact with the floor, adjust the height of the two rear feet by hand until the scale becomes stabilized. -
Page 7: Set Up The Clock
Set up the Clock Entering Clock Adjusting Mode 1. Press and hold the ‘Clock’ key on the right display panel for 2 to 3 seconds. The Clock LCD panel will flash ‘12 Hr’ or ‘24 Hr’ depending on the current display mode. 2. -
Page 8: Instructions For Use
7. Instructions for Use Weighing Procedure There are three ways to measure weight depending on the situation. • Auto-On Function can be used when the scale is in off-mode and the user is not on the scale. • Turn-On Function can be used when the scale is in off-mode and the user is not on the scale. •... -
Page 9: Wake-Up Function
Wake-up Function This function can be used if the user wishes to measure the weight immediately after the first reading. The scale must be in off-mode and the user must already be on the scale. 1. Press any key except ‘Zero’ key to activate (wake up) the scale. DO NOT press ‘Zero’... -
Page 10: Measuring Height Procedure
Measuring Height Procedure (WB-300MH and DH) The user should step on the platform without wearing shoes for accurate measurement. Always have someone assist the user for accurate measurement. 1. Adjust the Height Rod Arm position before the user steps on the platform. Place hand on the Height Rod Arm. - Page 11 2. Gently lower the Height Rod Arm until the Height Rod Arm touches the very top of the user’s head. CORRECT way to measure the height of 3. Read the measurement. (WB-300MH) If the subject is taller than 44", read the number just above the top of the Upper Pillar Column (see example #1).
-
Page 12: General Troubleshooting
8. General Troubleshooting Weight Capacity: ‘E’ If the weight is less than 10 lbs, the Weight LCD will display the weight, however, the reading will not lock in. Auto-on function will not work if the weight is less than 30 lbs. If the weight exceeds the scale’s maximum weighing capacity, the display panel will register ‘E’... -
Page 13: Replacing Batteries
Replacing Batteries The scale is operated by three (3) replaceable AA alkaline batteries for weighing and (one) 3-volt CR123 Lithium battery for clock operation. The battery box is located on the back of the LCD display. 1. Lift and remove the battery compartment cover located on the back of the LCD display. 2. - Page 14 ISO 9001 Certified Tanita Corporation of America 2625 South Clearbrook Drive Arlington Heights, IL 60005 USA Tel: +1-847-640-9241 Fax: +1-847-640-9261 www.tanita.com (800) Tanita-8 (USA & Canada Only) prosales@tanita.com Tanita France S.A. Villa Labrouste 68 Boulevard Bourdon 92200 Neuilly-Sur-Seine France Tel: +33 (0)-1-55-24-99-99 Fax: +33 (0)-1-55-24-98-68 www.tanita.fr...