Makita DUR361U Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Shaft pipe complete (cont.)
DISASSEMBLING
(4) Remove Cushion from Shaft pipe complete. (Fig. 5)
Fig. 5
1. Pull off Pipe rubber, and then loosen
M5x18 Hex socket head bolt.
[Gear case ass'y side]
[Motor side]
Pipe rubber
ASSEMBLING
(1) Assemble Pipe rubber, Cushion with Hanger to Shaft pipe complete. (Fig. 6)
Fig. 6
1. Set Hanger to Cushion.
Cushion
3. After assembling the above parts, adjust their positions as drawn below.
Then, fix Hanger with M5x18 Hex socket head bolt.
304 ~306mm
103mm
[Motor side]
Pipe rubber
Hanger
M5x18 Hex
socket head bolt
2. Shaft pipe ends have holes.
Install Cushion with Hanger and Pipe rubber to Shaft pipe complete from
Motor section side so that the long pitch between one end and one hole
faces to Cushion.
Hanger
Pipe rubber
447 ~ 457mm
Hanger
Cushion M5x18 Hex socket head bolt
2. Receive the end of Shaft pipe on wood and tap Cushion
with plastic hammer to remove Cushion and Hanger
from Shaft pipe.
[Gear case ass'y side]
[Motor side]
Wood as a
cushion
52.5 mm
(Long pitch)
Hanger
Cushion
[Motor side]
Handle holder
P 5/ 16
Plastic hammer
Hanger
Cushion
15 mm
holes
(Short pitch)
Shaft pipe complete
[Gear case ass'y side]
[Gear case ass'y side]