Makita DUR361U Technical Information page 12

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] - 4. Rotor, Stator (cont.)
ASSEMBLING
(1) Pass Rotor into Stator as drawn in Fig. 17.
Fig. 17
1. Holding Stator complete on workbench, slowly insert Rotor
in Stator complete until small ball bearing end reaches workbench.
small ball
bearing
(2) Assemble Rotor and Stator to Motor housing (L).
(3) Assemble Motor housing (R) to Motor housing (L). (Fig. 18)
Fig. 18
Two halves of Motor housing set are difficult to meet
their mating surfaces.
Therefore, put them on 1R350 to align the four holes
surfaces with Gear box contact portions.
And tighten three 4x18 Tapping screws for assembling
Motor housing (R) to Motor housing (L).
2. When the drive end of Rotor
reaches workbench, lift up
Stator complete slowly.
Four holes surfaces of
Motor housing set for
setting Gear box in place
P 12/ 16
4x18 Tapping
screw (3pcs.)
1R350