ENGLISH (Original instructions) SPECIFICATIONS Model DUR365U Type of handle Bike handle No load speed 3,500 / 5,300 / 6,500 min Overall length (without cutting tool) 1,754 mm Applicable cutting tool (country specific) Metal blade Nylon cutting head Plastic blade Cutting diameter...
Before starting the tool, read this instruction Before operation, examine the work area for manual to become familiar with the handling of stones or other solid objects. They can be thrown the tool. or cause dangerous kickback and result in Do not lend the tool to a person with insufficient serious injury and/or property damage.
Never attempt to switch on the tool if it is 13. Check the cutting attachment frequently during damaged or not fully assembled. Otherwise operation for cracks or damages. Before the serious injury may result. inspection, remove the battery cartridge and wait Adjust the shoulder harness and hand grip to suit until the cutting attachment stops completely.
To avoid kickback: Always wear protective gloves when handling the − Apply the segment between 8 and 11 o'clock. cutting blade. − Never apply the segment between 12 and 2 Always clean dust and dirt off the tool. Never use o'clock.
Page 6
ENC007-9 IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. Do not disassemble battery cartridge. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion.
Indicating the remaining battery capacity FUNCTIONAL DESCRIPTION (Only for battery cartridges with "B" at the end of the model number.) WARNING: Always be sure that the tool is switched off 1. Indicator lamps • 2. Check button and the battery cartridge is removed before adjusting or checking function on the tool.
If the tool is overloaded by entangled weeds or other Remaining battery capacity indication debris, the tool stops automatically, and all of the speed indicators blink. In this situation, turn the tool off and Battery indicator status stop the application that caused the tool to become Remaining battery capacity overloaded.
If you tap the reverse button while the tool's head • NOTE: is still rotating, the tool comes to stop and to be The tool is automatically turned off after the tool is • ready for reverse rotation. left one minute without any operations. Nylon cutting head (optional accessory) Speed adjusting NOTICE:...
Page 11
2. Bolt Replace the cup in case of crack or breakage due • to attrition. NOTICE: Be sure to use genuine Makita metal blade. • Turn the tool upside down so that you can replace the 015577 metal blade easily.
Failure to keep control of the tool could NOTICE: result in serious injury to the bystander and the Be sure to use genuine Makita nylon cutting head / • operator. plastic blade.
Page 13
Correct posture MAINTENANCE WARNING: Always hold the both grips firmly and position • WARNING: the tool on your right-hand side so that the Always be sure that the tool is switched off • shaft of the left handle is always in front of and battery cartridge is removed before your body.
Page 14
Wind all but about 100 mm of the cords, leaving the ends any other maintenance or adjustment should be temporarily hooked through a notch on the side of the spool. performed by Makita Authorized Service Centers, always using Makita replacement parts. 013826...
Instead, TROUBLE SHOOTING ask Makita Authorized Service Centers, always using Before asking for repairs, conduct your own inspection Makita replacement parts for repairs. first. If you find a problem that is not explained in the...
Page 16
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Cutter blade • Nylon cutting head • Nylon cord (cutting line) •...