Accessories
BCM On-Board Diagnostic System
•
The on-board diagnostic system of the BCM consists of the following functions:
–
Constant monitor
–
Self test
–
PID monitor
Constant Monitor
•
The constant monitor is carried out whenever the ignition is ON. If a fault is detected, a
DTC will be stored in the BCM. When the ignition is switched off, DTCs stored by the
constant monitor will be deleted. The constant monitor only monitors the following
systems:
–
Rain sensor
–
Battery voltage
–
BCM IC (Integrated Circuit)
Self Test
•
All systems other than those tested in the constant monitor, are monitored during the
self-test. If a fault is detected, a DTC will be stored in the BCM.
•
The self-test function allows BCM DTCs to be displayed on WDS. To view these,
connect WDS to the vehicle and select the option Toolbox→Self
Test→Modules→GEM.
•
When the ignition is switched off, DTCs stored by the self-test will be deleted.
•
To conduct the self test, the following conditions must first be met:
–
Ignition switch ON
–
All switches other than ignition switch OFF
–
All doors, bonnet, trunk lid and liftgate are closed and unlocked
–
Parking brake is engaged
09-8
Body & Accessories
Service Training Mazda6 Facelift