CHAPTER 4: Installing the Gateway
Installing the Gateway on a Wall
30
Wall-Mounted Installation
Wall-Mounting Screws
The screws provided in the wall-mounting kit are 1 in. (2.54 cm) in length and can be inserted into
wood or plastic walls of thickness 1 in. or more. Table 15 on page 30 specifies the screws that you
can use for mounting the gateway on a wall.
Table 15: Wall-Mounting Screws
Type of Wall
Screw Size (d x l)
Wood
3.5 X 25 mm
Plastic
3.5 X 25 mm
Note: For concrete or brick walls, use Type 5 self-tapping screws.
To install the gateway on a wall (see Figure 16):
1.
Ensure that the wall is smooth, flat, dry, and sturdy.
2.
Mark the points on the wall where you plan to drive the nail using the wall-mounting bracket
as a template.
3.
Make holes in the marked points using a powered drill.
4.
Insert the plug into the holes made.
5.
Position the wall-mounting bracket and place the screws in the plugs. Use a screwdriver to
secure them at all three mounting points (see Figure 15 on page 30).
6.
Hang the gateway on the two studs provided on the wall-mounting bracket (see Figure 16 on
page 30).
Figure 15: Installing the Wall-Mounting Bracket
Figure 16: Wall-Mounting the Gateway
Head Diameter
Screw Type
6.9 mm
Self tapping
6.9 mm
Self tapping
Copyright © 2010, Juniper Networks, Inc.