Throttle Mix; Fuel Mixture - FUTABA T32MZ Instruction Manual

This section contains information on the commands that
apply to helicopters only. For instructions on Airplanes
and Gliders, refer to the sections pertaining to those
aircraft. Each of these functions can be set independently
for different flight conditions. To get to these settings,
touch the desired function button to be accessed.
Use the Model Type function in the Linkage Menu to
select the swash type matched to the fuselage beforehand.
If you later change model types, all settings will be lost.
1. Set the throttle stick lower than the 1/3 point.
2. Push the INH button to activate the condition hold function.
running. An alarm indicates that the function is operating. It will prevent the engine from racing dangerously when adjusting the Idle-
Up settings.
must deactivate this function when you are through making adjustments.
The system will not allow you to activate/deactivate this function in either of the following states:
are on.
1/3 point.
PIT Curve:
THR Curve: Throttle curve and hovering trim adjustment
Acceleration:
Throttle Hold: Moves the throttle to idle during autorotation
Swash Mix:

Throttle Mix:

Pit to Needle:
Pit to RUD:

Fuel Mixture:

Gyro: Used to switch Futaba GY series gyro sensitivity
Governor: Used to switch RPM of the helicopter's head
Throttle Limiter: Limits the high range of the throttle movement by any slider or trimmer
＜ Model Menu (Helicopter Functions) ＞
162
before setting the model data at each function. (Up to
eight conditions can be used)
The AFR function, fuel mixture and other functions
common to all model types, are described in a separate
section.
Condition Hold function ON/OFF button