Table of Contents
Advertisement
TANDBERG 8000 MXP
In the example above, the system will start searching for available B-channels at channel 20,
since Search is set to High and High Channel is set to 20. The system will not search for
channels below 10, since Low Channel is set to 10. Furthermore if the user tries to make an 8
channel call, the call will be established with 6 channel, since Max Channels is set to 6.
4.8.1.2.4 Line Settings
T1 Cable
T1 Cable Length 1 specifies the distance to the CSU connected to the
Length 1
E1/T1 port 1 on codec 1.
T1 Cable
T1 Cable Length 2 specifies the cascading distance from the E1/T1 port
Length 2
2 on codec 1 to the E1/T1 port 1 on codec 2. Possible values are 0-115
feet, 80-215 feet, 180-310 feet, 280-410 feet, 375-510 feet, 475-605 feet,
575-690 feet.
E1-CRC-4 is used for most E1-PRI configurations. You can turn it off if
E1-CRC-4
not supported by your E1 network equipment.
For further information see
PRI/T1.
4.8.1.2.5
Advanced ISDN-PRI Settings
NSF is a non standard facility. Your network provider may require a service selection in your
ISDN configuration. Enter the Service code here. Valid NSF service codes are from 1 to 31.
Enter 0 to disable NSF service codes.
Example:
AT&T offers several digital switched
services. These include SDN with service
code 1 and ACCUNET with service code
6.
Below is a list of common service profiles.
As these profiles may change, contact
your service provider to get the correct
profile.
Service profiles
Service porfiles for
for AT&T:
Sprint:
NSF Service
NSF Service
Disable: 0
Reserved: 0
SDN (including
Private: 1
GSDN): 1
Inwatts: 2
Megacom 800: 2
Outwatts:3
Megacom: 3
FX: 4
Accunet: 6
TieTrunk: 5
Long Distance: 7
International 800:
Service profiles for
8
MCI:
MultiQuest: 16
NSF Service
104
Appendix
6: Connecting the system to
Advertisement
Table of Contents
