Starting Main Projector - Hitachi CP-X4021N User Manual

5.3 Starting Main projector

After performing Checking Main projector's operating status
confirmed that the two projectors are set to
is working at the moment. Since the setting for
while Main projector is working, this section shows you how you can switch from
Sub projector to Main.
1.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU
> SERVICE > COMMUNICATION
STACK menu will appear on screen.
(Operating Guide
2.
Check ALTERNATE MODE
If NORMAL is shown, two projectors are powered on in turn. So, if the stacked
projectors are restarted,
(1) Press STANDBY/ON
projector, and then
(2) After cooling down of the projector turn on again with pressing
button. Main projector will turn on this time.
If AUTO is shown, one of projector having a lamp that is shorter usage time is
powered on. So, even though the stacked projectors are restarted,
may not turn on. Take the following process to turn on
(1) Use the ▲/▼ button to point at
display STACK MODE
(2) Use the ▲/▼ button to point at OFF, and then press the ► button to complete
the setting. ( 23 )
(3) Display STACK MODE
(4) Use the ▲/▼ button to point at SUB, and then press the ► button to complete
the setting. ( 23 )
(5) After exiting, wait for 10 seconds or more.
(6) Press STANDBY/ON
projector, and then
(7) After cooling down of the projector turn on again with pressing
ON button. Main
LAMP MODE.
3.
Now, Main projector is working, so you can set or change the setting for
Intellectual Stack. Proceed to
NOTE • If Main projector cannot turn on with an error or something wrong on
Main, Sub projector will turn on even if you take the procedure as mentioned
above. Take necessary action for
change the setting for
All manuals and user guides at all-guides.com
> OPTION
> STACK
→
OPTION menu)
setting in the menu.
Main projector will turn on.
button on the remote control or control panel of
Sub projector will turn off.
STACK
dialog.
dialog again with the same process above.
button on the remote control or control panel of
Sub projector will turn off.
projector will surely turn on this time, even if
5.4 Setting on
Main
Intellectual Stack.
Setting for input port on menu
ALTERNATE MODE
Intellectual Stack
Main
MODE, and press the ► button to
menu. (
projector to recover first, and then
30
section, it is
and Sub projector
can be changed
Main
STANDBY/ON
Main projector
projector.
Main
STANDBY/
AUTO is set on
31 )