Inputting Image To Sub From Main - Video Signal (Either Component Or Video) - Hitachi CP-X4021N User Manual

Inputting image to Sub from Main
- Video signal (either COMPONENT or VIDEO)
1.
If STACK menu is already on screen, proceed to 3 below. Otherwise press
MENU button on the remote control.
If MENU dialog is displayed, use the ▲/▼ buttons to point at MAIN, and press
the ► button. Then, a menu appears on screen.
If not, a menu directly appears on screen.
2.
Press MENU button on the remote control or
control panel on
the ▲/▼/◄/► buttons, open
dialog. (Operating Guide
3.
If you input component signal on either
AUTO at the port. Then, use the ▲/▼/◄/► buttons to point at
press the ► button to complete the setting.
If you input video signal on either
at the port. If it is necessary to select a video format, use the ▲/▼/◄/►
buttons to point at
otherwise use the ▲/▼/◄/► buttons to point at
to complete the setting.
4.
Select VIDEO FORMAT
display VIDEO FORMAT
Select AUTO or appropriate format for the
port that you input video signal.
Then, use the ▲/▼/◄/► buttons to point at
complete the setting.
Inputting image of Sub and Main individually
1.
If STACK menu is already on screen, proceed to 3 below. Otherwise press
MENU button on the remote control.
If MENU dialog is displayed, use the ▲/▼ buttons to point at MAIN, and press
the ► button. Then, a menu appears on screen.
If not, a menu directly appears on screen.
2.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU
> SERVICE > COMMUNICATION
STACK menu will appear on screen.
(Operating Guide
(continued on next page)
All manuals and user guides at all-guides.com
Main projector. Then, using
COMPUTER IN
→ INPUT
COMPUTER IN 1
RETUEN and press the ◄ button to display
in INPUT menu to
dialog.
> OPTION
>
→ OPTION menu)
Setting for input port on menu
menu)
COMPUTER IN 1
or
EXIT
EXIT and press the ► button to
STACK
32
or IN 2 port, set
EXIT and
IN 2 port, set VIDEO
INPUT menu,
and press the ► button