Table of Contents
Advertisement
Setting input ports using menu
5.3 Starting up the Main projector
After performing section
two projectors are confirmed to have been set to ALTERNATE mode and the
Sub projector is currently operating. As the settings for Intellectual Stack can be
changed only when the Main projector is operating, this section explains how to
switch from the Sub projector to the Main projector.
1.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu appears on screen.
(Operating Guide
2.
Check the ALTERNATE MODE setting in the menu.
If NORMAL is displayed, the two projectors are turned on alternately. Therefore,
the Main projector is turned on if you restart the projectors.
(1) Press the STANDBY button on the remote control or STANDBY/ON button of
the Main projector. The Sub projector turns off.
(2) After the projector has cooled down, press the ON o r STANDBY/ON button to
turn on again. The Main projector is turned on.
If AUTO is displayed, the projector with the least light source usage is turned
on. Therefore, the Main projector may not be turned on even if you restart the
projectors. Follow the procedures below to turn on the Main projector.
(1) Use the ▲/▼ button to highlight STACK MODE, and press the ► button to
display the STACK MODE dialog.
(2) Use the ▲/▼ button to highlight OFF, and then press the ► button to complete
t t i n g . ( 20 )
t h e s e
(3) Repeat the above procedures to display the STACK MODE dialog again.
(4) Use the ▲/▼ button to highlight SUB, and then press the ► button to
complete the setting. ( 20 )
(5) After exiting the menu, wait for 10 seconds or more.
(6) Press the STANDBY button on the remote control or STANDBY/ON button of
the Main projector. The Sub projector turns off.
(7) After the projector has cooled down, press the ON o r STANDBY/ON button to
turn on again. The Main projector is turned on even if ALTERNATE MODE has
been set to AUTO.
3.
You can change the settings for Intellectual Stack now that the Main projector
is operating. Go to
• If the Main projector cannot be turned on due to an error, the Sub
NOTE
projector is turned on even if you follow the procedures above. Take necessary
actions to fix the Main projector, and then change the settings for Intellectual
Stack.
5.2 Checking Main projector's operating
→
OPTION
menu)
5.4 Setting the
menu.
(
29 )
28
status, the
QM00974-1
Advertisement
Table of Contents
