Table of Contents
Advertisement
CAUTION
Note
3-6 System Setup and Functional Tests
Attaching the Power Module and Power Cords
1. Attach the power cord module (found in the accessories carton) to
the rear-upper cart support. Use the metal posts located on the far
right-hand side of the cart when viewed from the rear of the cart.
The power cord module is grooved to slip over the metal posts.
2. Plug the power cord into the power module for the two ampli er
power supplies (located on the bottom of the tiltable shelf).
3. Plug in the spectrum analyzer using one of the 30-inch power
cords.
4. Attach the 8-foot long power cord supplied with the system to the
power cord module.
Notice that the input end of this cable is speci c to the country
receiving the system. Before connecting the system to a power
source, make sure that the spectrum analyzer line module is
con gured for the proper voltage requirements. Refer to Chapter 9 of
HP 8560 E-Series Spectrum Analyzer User's Guide
the
instructions.
Installing the Accessories and Test Set in the System
1. Open the drawer of the cart and remove all of the contents except
the foam ller. Position the foam ller at the back of the drawer.
2. Remove the shipping foam with the accessories from the accessory
carton and place it in the front of the drawer. This is a convenient
place to store the system hardware.
3. Remove the test set with its attached three-meter RF cable
assembly from the smallest carton and place it on top of the
spectrum analyzer. Position the analyzer handle so that it rests
against the back of the analyzer.
Since the system functional tests require the RF cable assembly to
be removed from the INPUT 50
of the analyzer, you may elect to
perform the system functional tests at this time. Additional equipment
and accessories will be required to perform these tests. Refer to
\System Functional Tests" later in this chapter.
for complete
Advertisement
Table of Contents
