Page 1
All manuals and user guides at all-guides.com GEBRAUCHS- UND MONTAGEANWEISUNG INSTRUCTIONS FOR FITTING AND USE INSTRUCTIONS DE MONTAGE ET D’UTILISATION GEBRUIKS- EN MONTAGE-INSTRUCTIES ISTRUZIONI PER L’USO ED IL MONTAGGIO INSTRUCCIONES PARA EL USO Y MONTAJE MANUAL DE INSTRUÇÕES DE USO E DE MONTAGEM œƒ«√…≈”...
All manuals and user guides at all-guides.com You now own a glass ceramic hob. Chapters 2 and 3 of these Operating Instructions contain informations on how you can make sure that your hob gives many years of service. These Operating Instructions are for use with several types of hobs. The rating label on the front of these Instructions will show you which type you have bought.
All manuals and user guides at all-guides.com 1. General These Operating Instructions are for use with several types of hobs. Read only the part that applies to your appliance. This appliance may only be connected to the electricity supply by an approved electrician. The plastic covering or veneer of the built-in furniture must have been applied with a heat-resistant adhesive (150°C).
All manuals and user guides at all-guides.com 2.4 Twin circuit cooking zone With a two-circuit cooking zone you can switch on the small heating circuit separately or add the large heating circuit. Thus you can adapt the size of the heated cooking zone to your pot. Please note the separate information for built-in ranges, switch boxes or electronic controls in the separate operating instructions.
All manuals and user guides at all-guides.com 2.7 Cleaning Always clean the hob after it has cooled down. Even the slightest amount of dirt will burn into the surface the next time you switch it on. Use only recommended cleaners. Steel wool, cleaning sponges and abrasive powders scratch the surface.
All manuals and user guides at all-guides.com 2.8 Maintenance If cared for properly, your hob will remain beautiful for many years and cleaning will be easier. To care for your hob we recommend that you use “Cerafix”. The high silicone percentage of this cleaner creates a protective film which keeps off water and dirt.
All manuals and user guides at all-guides.com 3. For the technician 3.1 Worktop cut-out Carry out all cutting out of furniture units and worktops before fitting the appliance. Remove all sawdust and chips. The dimensions of the worktop recess can be seen in the dimension drawing (figs. 1–3). The worktop cut-out should be properly milled and sealed afterwards with heat and humidity-resistant lacquer.
All manuals and user guides at all-guides.com 3.3 Electrical connections (connected loads) (Connected loads and model designation: see front of the operating instructions) This appliance may only be connected to the electricity supply by an approved electrician who must ensure that the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV, etc.).
Page 9
All manuals and user guides at all-guides.com Types: .GK 58 .., .GK 75 .. Type: .GK 58 .. Fig. 1 Fig. 2 Type: .GK 75 .. Fig. 1 Fig. 2 Minimum distances to adjacent walls Cut-out dimension Outside dimensions of recess Fig.
Page 10
All manuals and user guides at all-guides.com Types: FGK 58 .., FGK 75 .. Type: FGK 58 .. Fig. 1 Fig. 2 Type: FGK 75 .. Fig. 1 Fig. 2 Minimum distances to adjacent walls Cut-out dimension Outside dimensions of recess Fig.
Need help?
Do you have a question about the CK 580 and is the answer not in the manual?
Questions and answers