Mixed and gas fuelled built-in hot plates (19 pages)
Summary of Contents for Kuppersbusch GWS 307
Page 1
Gebruiksaanwijzing en montagehandleiding Instructions d’installation et d’utilisation Istruzioni per l’installazione e per l’uso Instrucciones de uso y de montaje Instruções de uso e instalação Οδηγίες χρήσης και συναρµολόγησης Πεδίο µαγειρέµατος µε αέριο GWS 307, GKS 324, GKS 644, GKS 954...
Technical data ........25 Power, consumption and installation dimensions Table Permitted gas types and gas pressures Diameter of injectors Gas connection schedule Table Rated load GWS 307, GKS 324, GKS 644, GKS 954...
High speed burner Wok burner 3-part pan support Gas is connected 1/2" (ISO 7) downwards at the rear in the centre. Gas is connected 1/2" (ISO 7) downwards at the rear in the centre. GWS 307, GKS 324, GKS 644, GKS 954...
• Do not wedge in freely laid supply hoses or place them on the hot hob. • Minimum distance to adjacent wall cupboards hung high above the oven is 650 mm. Please take note of the instructions of the respective manufac- turer of the cooker hood. GWS 307, GKS 324, GKS 644, GKS 954...
"high flame" position. content boils too much switch The burner at the cooking zone is automatically ignited by the electric igni- to a lower cooking level. You ter. need less energy and avoid hu- GWS 307, GKS 324, GKS 644, GKS 954...
Smell of gas in the line or gas connection do not ignite any naked room. tap or defective wok flames, burner. notify a qualified gas fit- ter, your gas supplier, or customer service imme- diately. GWS 307, GKS 324, GKS 644, GKS 954...
The installation space must have a minimum volume of 20 m³, and must have a window or door to the outside for ventilation purposes. The hob is built into a worktop opening, which must be cut in accordance with the dimensions specified below. GWS 307, GKS 324, GKS 644, GKS 954...
– Remove the glass-ceramic top plate from the packaging. Adhere the sealing strip supplied onto the bottom of the glass-ceramic top plate so that it is flush with the edges. – Place the glass-ceramic top onto the worktop so that the brackets adhered GWS 307, GKS 324, GKS 644, GKS 954...
Page 9
– Remove the burner components from the packaging. ping rings, that the approx. 1.5 cm wide lip of the gasket is properly in- GWS 307, GKS 324, GKS 644, GKS 954...
– Adjust the MS injector until the clearance (X) corresponds with that given in the following table. Re-tighten the locking screw (10.8). – After exchanging the nozzle, check, for any gas leaks. GWS 307, GKS 324, GKS 644, GKS 954...
Page 11
– Remove the burner rings and cap of the wok burner again. – Turn the switch back to its original position, or re-install the switch, spring and MS-washer and secure them with the retaining ring. – Perform a function test. GWS 307, GKS 324, GKS 644, GKS 954...
The appliance must be inspected in accordance with the national regulations as well as the EU Gas Equipment Directive (90/396/EEC) and EN 30. Table Permitted gas types and gas pressures Land (ISO abbreviation) Category Natural gas Liquefied petroleum gas Butane/propane gas II 2H3+ United Kingdom (GB) H (G20) 20 mbar (G30/G31, 3+) 28-30/37 mbar GWS 307, GKS 324, GKS 644, GKS 954...
Need help?
Do you have a question about the GWS 307 and is the answer not in the manual?
Questions and answers