Table of Contents
Advertisement
32
www.aeg.com
start of the cleaning with the function:
END.
The signal sounds at the end of cleaning.
2. Press any button to stop the signal.
3. Turn off the oven.
To stop the cleaning before it finishes
turn the knob for the heating functions to
the off position.
4. When the oven cools down, clean
the cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Catalytic fan cover
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
The fan cover with a catalytic coating is
self-cleaning. It absorbs fat which collects
on the walls while the oven works.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Remove all the accessories from the
oven.
2. Clean the oven floor with warm water
and washing up liquid, then dry it.
3. Set the function
4. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
5. When the oven is cold, clean it with a
soft and wet sponge.
Spots or discolouration of the catalytic
surface have no effect on catalytic
properties.
11.6 Cleaning reminder
As a reminder that catalytic cleaning is
necessary, CATA flashes in the display
for 10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes out:
• after the end of the Catalysis function.
• if you press
time.
.
and
at the same
11.7 Oven ceiling
WARNING!
Deactivate the appliance
before you remove the
heating element. Make sure
that the appliance is cold.
There is a risk of burns.
Remove the shelf supports.
You can fold down the heating element
on the oven ceiling to clean the oven
ceiling easily.
1. Hold the heating element with two
hands at the front.
2. Pull it forwards against the spring
pressure and out of two holders.
The heating element folds down.
3. Clean the oven ceiling.
4. Install the heating element in the
opposite sequence.
Install the heating element
correctly above the supports
on the inner walls of the
appliance.
5. Install the shelf supports.
11.8 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
Advertisement
Table of Contents
