Position Of The Interfaces - Siemens Sinumerik 801 Technical Manual

SINUMERIK 801 Control System
1.3

Position of the Interfaces

General
Interfaces
1-6
Interfaces of the control system are positioned in the rear of the CNC system,
see Fig. 1-3 below.
Interfaces of the SINUMERIK 801 control system are shown as below:
Fig. 1-3 Position of SINUMERIK 801 interfaces
Notice
See Section 2.3 "Interfaces and Cables" for detailed description of each
interface.
SINUMERIK 801
Start-Up