Advertisement
Quick Links
Unidrive M600-M70X, F300, H300, E200 & E300
Size 6 Through-panel Mounting Installation Sheet
1
Safety information
Follow the instructions
The mechanical and electrical installation instructions must
be adhered to. Any questions or doubt should be referred to
the supplier of the equipment. It is the responsibility of the
WARNING
owner or user to ensure that the installation of the drive and
any external option unit, and the way in which they are
operated and maintained, comply with the requirements of
the Health and Safety at Work Act in the United Kingdom or
applicable legislation and regulations and codes of practice in
the country in which the equipment is used.
Competence of the installer
The drive must be installed by professional assemblers who
are familiar with the requirements for safety and EMC. The
assembler is responsible for ensuring that the end product or
system complies with all the relevant laws in the country
WARNING
where it is to be used.
2
Introduction
This document covers through-panel mounting instructions for Unidrive
M600 / M70X, F300, H300, E200 & E300 Size 6 drives. The standard
drive is rated to IP20 pollution degree 2 (dry, non-conductive
contamination only, NEMA 1). However, it is possible to configure the
drive to achieve IP65 rating (NEMA 12) at the rear of the heatsink for
through-panel mounting.
The following items are supplied in the kit bag:
Table 2-1 Contents of kit box (CT Part Number: 3470-0055-00)
Description
Through panel mounting gasket
Through panel securing brackets
Through panel mounting
instructions sheet
The following items are included in the kit boxes 3470-0054 and
3470-0037, either of which can be supplied with the drive.
Table 2-2 Additional items provided
Description
Frame 6 mounting brackets
The following items are not included in the kit box, however they
are required to complete the installation.
Table 2-3 Additional items required
Description
Suitable M6 fastener
Suitable M5 fastener
1
3
3.1
Figure 3-1 Installing the gasket
1. Install the through panel mounting gasket onto the drive with the kit
Image
Qty
Figure 3-2 Frame 6 drive and assembled gasket
x 1
x 3
x 1
Image
Qty
x 2
2. Drive and assembled gasket (2).
Image
Qty
6
6
Instructions
Preparing for installation
provided as shown (1).
0478-0030-02
Advertisement
Related Manuals for Nidec M600-M70X
Summary of Contents for Nidec M600-M70X
- Page 1 Unidrive M600-M70X, F300, H300, E200 & E300 Size 6 Through-panel Mounting Installation Sheet Safety information Instructions Preparing for installation Follow the instructions The mechanical and electrical installation instructions must Figure 3-1 Installing the gasket be adhered to. Any questions or doubt should be referred to the supplier of the equipment.
- Page 2 Preparing the backplate Figure 3-3 Backplate mounting detail Prepare the backplate in accordance with the mounting dimensions shown in Figure 3-3. Installing the drive Figure 3-4 Installing the lower mounting bracket Figure 3-5 Inserting the drive through the backplate Loosely secure the lower mounting bracket to the mounting plate, using three M6 fasteners as shown in Figure 3-4.
- Page 3 Figure 3-6 Securing the upper mounting bracket Locate the upper mounting bracket into the drive chassis upper mounting slots and secure the drive to the mounting bracket using M6 fasteners. Make sure the M6 fasteners on the lower mounting bracket are fully secured before proceeding further.